Proceedings of the
5th International Seminar on
ORC Power Systems
9 - 11 September 2019, Athens Greece
Home Program Author Index Search

Rotary Vane Expander – Analysis and Prediction of Delayed Chamber Closure


Go-down orc2019 Tracking Number 32

Presentation:
Session: Session 4A: Volumetric Expanders (1)
Room: Olympia
Session start: 14:00 Tue 10 Sep 2019

Vaclav Vodicka   Vaclav.Vodicka@cvut.cz
Affifliation: University Centre for Energy Efficient Buildings, Czech Technical University in Prague, Třinecká 1024, 273 43 Buštěhrad Czech Republic

Vaclav Novotny   Vaclav.Novotny@cvut.cz
Affifliation: University Centre for Energy Efficient Buildings, Czech Technical University in Prague, Třinecká 1024, 273 43 Buštěhrad Czech Republic

Zbynek Zeleny   zbynek.zeleny@cvut.cz
Affifliation: University Centre for Energy Efficient Buildings, Czech Technical University in Prague, Třinecká 1024, 273 43 Buštěhrad Czech Republic

Jakub Mascuch   Jakub.Mascuch@cvut.cz
Affifliation: University Centre for Energy Efficient Buildings, Czech Technical University in Prague, Třinecká 1024, 273 43 Buštěhrad Czech Republic


Topics: - Experimental activities and techniques (Topics), - Volumetric expanders (Topics), - Oral Presentation (Preferred Presentation type)

Abstract:

Rotary vane expander (RVE) is a perspective solution in the case of requirement for expanders with low power output in range of single kW as they can provide attractive cost to performance ratio, especially in case of small series or single units manufacturing. Specific feature of the RVE are the vanes sliding on the surface of a stator cylinder, thus creating chambers. Permanent contact between the vanes and the stator is essential from the perspective of expander efficiency and lifetime of the vanes. If the vane does not maintain contact with the stator, a phenomenon called vane chatter occurs. In this case, the working chamber is not properly formed, which is associated with excessive leaks of the working fluid from the working chamber. If this occurs during the filling phase, the mass flow of the working fluid through the machine will be greatly increased, while at the same time the overall efficiency of the expander will be significantly reduced. This work provides a mathematical model, which extends previous models describing internal leakage pathways by prediction of the occurrence and extent of the delayed closure of the working chamber in the filling phase. The model is based on combination of 1D quasi-steady flow of working fluid through a set of described leakage pathways combined with a dynamic model of vanes, describing their radial position. The model results are after preliminary assessment in agreement with experimental measurements on an in house developed RVE with MM as working fluid. Vanes of various mass were tested for a given range of rotational speed as the difference in the centrifugal force acting on the vanes has major influence on the proper closure of the working chamber (but also on friction losses). This combined model can serve for future throughout optimization or check of occurrence of delayed chamber closure in RVE design works.